ET Grips for Parma handle controllers

- ET Slotworks has introduced a new ET Grip for the Parma style controller handle. I must say that I wasn't sure that I liked this handle over the first one that he made. After a direct "Feel" comparison, I was sold on this new version. Here are a few reasons why it is better.
1. It is softer and actually allows your hand to mold into it for a more comfortable grip.
2. It is porous so it will actually absorb some of the hand sweat from the big race.
3. It isn't quite as tight as the first version so installation is much easier. A very small amount of dish soap wiped modestly around the inside of the grip allows it to install in less than 10 seconds.
4. Most important of all reasons. It comes back off without being destroyed. This means you can work on your controller and reuse the grip.
...Jerry

ET Grip $6.49

If purchased at the same time as a new BRP Controller it will be installed free upon request. Enclosed are photos of the grip installed on a Stage I controller. These are cut "open-bottom" at our request to allow full access to the fuse holder.

Ordering information

brp Home Page Bat-Jet bodies NASCARZ bodies Magnet Matcher Nitro controllers Nitro Stage I & II Controllers PitPal T-Jet Front Ends T-Jet Tires & Wheels T-Jet Electrical parts T-Jet Gears T-Jet Tools & Supplies Decals